You may be trying to access this site from a secured browser on the server. Please enable scripts and reload this page.
Turn on more accessible mode
Turn off more accessible mode
Skip Ribbon Commands
Skip to main content
Turn off Animations
Turn on Animations
Secțiune pentru instalatori
Secțiune pentru instalatori
See all Campanii
See all Produse noi
Boiler, buffer tank, mixed circuit, DHW (Hy0403p)
Outdoor temperature-compensated flow temperature control for radiators, convectors or low temperature heating circuits. Hot water control. Integrated differential temperature control for controlling a switching valve for buffer storage. Burner control for demand-based control of all boiler types (one-stage).
Note: System no. 403 means
that certain parameters must be set for this application to function.
Domestic Hot Water
The basic functions are contained in an indestructible program.
All the parameters are predefined with sensible basic settings and allow individual adjustments as necessary. PCs are not required for this.
All the relay outputs can be tested manually.
Single stage boiler control on/off or OpenTherm
Boiler is only used in case the buffer cannot provide the required temperature
Time switch for daily, weekly and holiday programs for heating circuits
Optimisation of switch-on times
Caretaker function, frost protection function
Outdoor temperature-compensated heating circuits, with room tie-in as necessary
Min./max. limiting of flow temperature
Cooling function - switchover based on outside temperature
Hot water control
Time switch with daily and weekly program for hot water filling pump
Anti-legionella automatic system
Hot water priority circuit
A differential temperature control function does switch pump on VA2 to on if temperature at VE2 is higher than on KSPF sensor
Combination option of up to five freely-selectable SMILE controllers
Communication takes place over the system bus without additional interfaces
Distance (max. 100 m)
All the data required for the control system is communicated
Remote operation with the wall modules SDW.. also takes place using the system bus
If the required temperatures cannot be achieved within a reasonable time, or sensors interrupt or short-out, then the controller will generate a fault message.
Add to Binder
Application for Smile digital controller
Microprocessor controller for heating circuit, boiler and hot water control
With connectable terminal strips for control panel installation
Outside air temperature sensor
Contact temperature sensor VF
Boiler, hot water, buffer, and waste heat temperature sensor (without well) WF, SF, VE1, KSPF, VE2 (5)
Remote control with temperature selector/sensor and mode switch
Immersion temperature sensor (instead of SF20-B54)
Hot water sensor with optional NIRO immersion well (instead of KTF20-65-2M)
Easy-to-use remote operation with display and complete programming unit along with temperature sensor/selector (instead of SDW10)
Base for Smile Controller, for control panel installation as touch protection
Connecting base for wall installation of SMILE panel models
Reducing attachment frame for control panel installation, assuming available control panel cut-out on controllers ZG52 /53 /55 / 82 /85 or ZG215 /215V /252 /254