Skip Ribbon Commands
Skip to main content

Leakage Alarm System SeaHawk

Leakage Alarm System SeaHawk

The SeaHawk Leakage Alarm System is a distance-read leak detection supervised system that continuously monitors a length of cable for continuity an...

Product Description

The SeaHawk Leakage Alarm System is a distance-read leak detection supervised system that continuously monitors a length of cable for continuity and leaks. When a cable break, contamination or leak is detected, the module calculates and annunciates the distance to the leak. This distance can then be cross-referenced with a cable reference map or immediately located by accessing an interactive map.
The SeaHawk controller can be applied for standalone operation including detection annunciation display or can be integrated into a building management system via Modbus to the Hawk controller providing a centralized source of monitoring, communication and notification capabilities.

Technical Properties

Mounting DIN rail, or wall mounting with screws
Protection class IP30
Control software configurable with COACH-AX software
Hardware inputs sensing cable for water detection, length 11..3000 m
Output signal
  • relay SPDT contact 30 Vdc 5 A resistive, 250 Vac 8 A resistive; minimum load 10 mA 5 Vdc (signal)
  • audible alarm 85 dB(A) at 0,6 m
Display functions
  • red LED for leak alarm
  • yellow LED for cable contamination or fault
  • 4-character LED display for distance or fault status
Stand-alone operation yes
Bus system description EIA-485, Modbus (RTU)
Type of terminals screw terminals with terminal block
Housing (HxWxD) 109 mm | 71 mm | 61 mm
Power supply 12..24 Vacdc

Продукти

Product Type
SeaHawk Controller

LAS-SH10

Accessories and replacement parts

Cables

Image Description Product Type Downloads
Sensing cable, length 7,6 meter LAS-SC7  
Sensing cable, length 15,2 meter LAS-SC15  
Sensing cable, length 30,4 meter LAS-SC30  
Non-sensing cable, length 7,6 meter LAS-NSC7  

Spot detector

Image Description Product Type Downloads
Spot detector LAS-SD-Z  

Accessories

Image Description Product Type Downloads
Weighted cable connector (simulates 15,2 meter of sensing cable) LAS-WCCS  
Cable fixations (installation fixation for both the sensing cable and the non-sensing cable (25 pieces) LAS-CLIP-25  
Power supply 230 V, 50 Hz / 24Vdc LAS-PSWA